(561) 678-4182 Request an estimate

Broward County, Florida

Impact Windows and Doors in Broward County

Hurricane-rated openings installed into concrete that has been properly repaired.

In short

Who handles impact windows and doors in Broward?

Unified GCS installs impact windows and doors in Broward County for condominium associations and commercial buildings. The work involves measuring each opening, submitting product approvals valid for the High-Velocity Hurricane Zone with the city permit, removing the old frames, repairing the concrete and stucco around the opening, anchoring the new units and sealing the perimeter.

Impact Windows & Doors · Broward

Impact windows and doors in Broward County are installed under the High-Velocity Hurricane Zone provisions of the Florida Building Code, which apply only in Broward and Miami-Dade. Unified GCS installs impact-rated windows, sliding glass doors and common-area entry systems for condominium associations and commercial buildings, and we repair the concrete and stucco around each opening before the new unit goes in.

That second part is what separates a restoration contractor from a window installer. Sills, jambs and headers in older buildings are often cracked or spalled where the original frame anchors corroded. A new impact door fastened into damaged concrete will not perform to its rating and will leak at the perimeter. We repair the opening, set and anchor the unit as its product approval requires, and waterproof and seal the joint between frame and wall.

Written and reviewed by the Unified GCS project team, 45 years in concrete restoration and construction. Last reviewed October 2026.

Impact windows and doors in Broward County by Unified GCS
Broward County coastal condominium buildings

Local conditions

Openings on older Broward County condominium towers

The oceanfront buildings in Fort Lauderdale, Pompano Beach, Hollywood and Hallandale Beach that date from the 1960s to the 1980s were built with non-impact sliding doors and windows, many of them later covered by accordion or roll-down shutters. The original aluminum frames have pitted, the tracks no longer drain and the steel fasteners that hold them have rusted into the slab edge and sill.

Associations in Broward commonly replace openings building-wide during or right after a concrete restoration project, when swing stages are already on the building and balcony slabs and thresholds are being rebuilt. Products installed here must carry an approval valid for the High-Velocity Hurricane Zone, and the installation must match the approved anchoring and substrate conditions. The city building department inspects the installation under the permit.

Where this work is needed

Openings we replace on Broward buildings

Oceanfront towers in Broward have the largest openings: full-width sliding glass doors onto balconies, floor-to-ceiling fixed glass at corners and wide lobby storefronts facing the beach. Wind pressure rises with height and at building corners, so the same door may need a different rated product on an upper corner unit than on a lower floor. Buildings on the Intracoastal Waterway in Fort Lauderdale, Pompano Beach and Hallandale Beach have similar openings with less salt damage to the concrete surrounding each frame.

Inland Broward condominiums present a different set of openings. Three- and four-story buildings in Tamarac, Sunrise, Lauderhill, Margate and Coconut Creek commonly have original awning or jalousie windows facing the catwalk, a unit entry door opening onto that walkway and a sliding door to a small rear balcony or screened porch. Frames sit in stucco over concrete block instead of poured concrete. Commercial work in the county includes storefronts, entry doors and lobby glazing at offices, clinics and retail centers.

What is included

Impact windows and doors in Broward County: scope of work

  1. 01Impact window and sliding glass door installation
  2. 02Storefront and common-area entry systems
  3. 03Opening repair: sills, jambs and headers
  4. 04Perimeter waterproofing and sealants
  5. 05Stucco and finish restoration around new openings
  6. 06Building-wide replacement programs for associations
Impact Windows & Doors work in progress in Broward County

Our approach

Replacing openings unit by unit in an occupied building

Each opening is measured, and shop drawings and product approvals are submitted with the permit. On installation day the old unit is removed, the opening is inspected, and any concrete or stucco repair is completed before the new frame is set. We aim to remove and replace within the same day so no unit is left open overnight.

Residents receive a schedule by stack and floor, with instructions for moving furniture and window coverings away from the work. Floors are protected along the path to the opening. After the frame is anchored, the perimeter is sealed, the sill is tied into the balcony waterproofing where there is one, and interior and exterior finishes are restored around the new unit.

Unified GCS has 45 years in the business. See the full impact windows & doors service or everything we do in Broward County.

Planning the project

Planning a building-wide window project in Broward

A building-wide replacement in Broward starts with the association's documents and a survey. The documents establish whether the association or each owner is responsible for the openings, and the board adopts one specification for product, frame color and glass. Every opening is then measured, because sizes vary more than the original drawings suggest. On beachfront property, glass tint is part of the specification: sea turtle nesting season in Broward runs from March 1 to October 31, and coastal cities have lighting ordinances the building official can explain.

Lead time and weather govern the schedule. Units are made to order after the permit drawings are approved, so the order is placed months before installation. Each opening is removed and replaced within one working day, and crews do not open more than they can close if a storm is forecast. Boards in Broward often align the project with balcony repairs or repainting. Florida's structural integrity reserve study lists windows and exterior doors as a component where the association is responsible for them.

How a project runs

From the first site walk to the closed permit.

  1. 01

    Walk the property

    We start on site with your manager, board or engineer and look at the conditions first-hand.

  2. 02

    Define the scope

    You get a written scope tied to the engineer's report or our findings, with the phasing spelled out.

  3. 03

    Plan access and safety

    Swing stages, shoring, barricades, parking and resident notices are set before the first cut.

  4. 04

    Do the work

    Our crews carry out the repairs in sequence, with inspections at the points the engineer requires.

  5. 05

    Close it out

    Final inspections, permit closure and a record of what was done, for the association's files.

Summary

Key takeaways for Broward owners and boards

  • 01

    Upper floors and corner units on Broward oceanfront towers can require higher-rated products than lower floors of the same building.

  • 02

    Inland Broward condominiums often have original awning or jalousie windows and entry doors opening directly onto a catwalk.

  • 03

    Beachfront buildings in Broward should confirm glass tint with the city because of sea turtle lighting ordinances.

  • 04

    Impact units are made to order, so a Broward association should expect a wait between permit approval and installation.

Questions

Impact Windows & Doors in Broward: common questions

What approval do impact windows need in Broward County?

Broward is within the High-Velocity Hurricane Zone of the Florida Building Code. Windows and doors installed here must have a product approval valid for that zone, such as a Miami-Dade Notice of Acceptance, and be installed as that approval describes. The city building department reviews the approvals with the permit.

Should a Fort Lauderdale condominium replace sliding doors before or after balcony repairs?

The best sequence is together or immediately after. Balcony repairs often rebuild the slab edge and threshold the door sits on, and the new door sill must be tied into the balcony waterproofing. Replacing doors first risks damaging them during chipping and leaves the threshold detail unresolved.

Can individual owners in a Hollywood or Hallandale Beach building replace their own windows?

That depends on the condominium documents, which define who is responsible for windows and doors and what specifications owners must follow. Many associations adopt a building-wide standard for product, color and installation method so the facade stays uniform and the perimeter waterproofing is consistent.

Do beachfront condominiums in Fort Lauderdale or Pompano Beach need tinted glass in new windows?

Coastal cities in Broward have beachfront lighting ordinances to protect nesting sea turtles, and these can affect how much interior light glass facing the beach may transmit. Requirements differ by city and by whether the work is new construction or replacement. The building official confirms what applies, and the tint is written into the product specification.

Why do upper-floor units in a Hollywood tower need different windows from lower floors?

Design wind pressure increases with height and is higher at the corners of a building. Each product approval lists the pressures and sizes a window or door is rated for. An engineer calculates the pressure at every opening, and each unit is matched to a product rated at or above that figure and anchored as its approval requires.

How long does it take to replace windows and sliding doors in a Broward County condominium?

Most of the time is spent before installation: surveying, shop drawings, permit review and manufacturing. Once product arrives, crews typically complete a set number of openings each day, stack by stack. For impact windows and doors in Broward County we issue a unit-by-unit calendar so each household knows its installation day well in advance.

Regulations referenced

This page is general information, not legal or engineering advice. Inspections are performed by licensed engineers and architects, and your building official sets the dates that apply to your property. Unified GCS is the contractor that carries out the repairs.

Referred by an engineer?

Have drawings, specifications or a full set of bid documents?

Most of our restoration, pool and roofing work comes to us through structural engineers, property engineers and board members. When the scope is already drawn and specified, we price exactly what is on the documents, flag anything that needs a question, and show every line so the board can compare bids fairly.

Request an estimate

Let's look at your building.

Send us the engineer's report, a few photos or a short description. We will schedule a site visit and follow up with a written scope.

  • 45 years in the business
  • Broward and Palm Beach counties
  • Reply within one business day

Prefer to talk?(561) 678-4182

Optional. For a large bid package, paste a download link in the message instead. Images or PDF, up to 50 MB.

We reply within one business day. Your details are only used to respond to this request.

Call Request an estimate